Mutoh PJ-1634NX / PJ-2234NX

Pressing the Properties button next to the Printer Model window on the Imaging Configurations screen will launch a control panel for this printer.

This page of the Properties control panel allows you to select a print mode, the print direction, the number of passes, the amount of time that the ink will wait to dry at the end of a print, and the heater and dryer temperatures.

• Print Mode: Select the ink type and printing resolution
• Print Direction: Print in both directions (bi) or one direction (uni)
• Pass Count: Select pass count / Overlap
• Drying Time: Select the drying time in seconds
• Heater Controls:
  • On/Off buttons on individual heaters allow one to turn each heater on or off
  • Adjust heater temperature in degrees centigrade

Advanced Settings:

The Advanced page allows you to select a media type, the media stiffness, the thickness of the media, the head height, and the amount of feed correction necessary to eliminate microbanding.

• Use Advanced Settings: Choose whether to disable the advanced settings
• Media Selection: Choose from a selection of media types
• Media Stiffness: Will adjust the power of the media vacuum
• Media Thickness: Select thickness of the media in mm
• Head Height: Set the gap between the platen and the head
• Send Feed Correction: Check to send a value
• Media Feed Correction: Adjust the amount of feed correction necessary to eliminate micro-banding